I'm using CWALSHT to design an anchored sheet pile and everything works out fine for the "design" parameters. When I enter in sheet pile data (depths, E, I) for the “analysis” option, I get the attached error saying that "Wall bottom has been specified above the soil surface." This isn't the case though. Wall bottom is set at 1055. Left surface set at 1062 and right surface set at 1075. My soil layer data goes well below the bottom of the wall too. Any ideas what I'm doing wrong?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
CWALSHT
- Thread starter jrm81
- Start date