Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Cutting Helical sweep from a cylinder 1
- Thread starter snomann65
- Start date
-
1
- #2
snomann65
You would use the insert- cut- sweep when you are creating the sweep for the first time. Another way would be to uncheck the merge result box when creating the sweep. You can also edit definition of the existing part and uncheck it there. You would then be left with two solid bodies, and can use the insert- feature- combine from the top pull down menu to subtract the sweep from the tube.
You would use the insert- cut- sweep when you are creating the sweep for the first time. Another way would be to uncheck the merge result box when creating the sweep. You can also edit definition of the existing part and uncheck it there. You would then be left with two solid bodies, and can use the insert- feature- combine from the top pull down menu to subtract the sweep from the tube.
- Status