Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cutting 1" Mild Steel

Status
Not open for further replies.

Tkuba

Agricultural
May 5, 2020
1
Good Morning,

I am looking to get help with cut conditions for 1" Grade 50 mild steel. If anyone has suggestions I would greatly appreciate it. The condition I have attached in the picture worked on the last sheet we had received in but now does not work at all i get chatter on the whole part. I need a cut condition that will work with good quality steel and a poor quality steel if possible?
IMG_1275_h4niko.jpg


Thank you,
 
Replies continue below

Recommended for you

What type of nozzle are you using? What are your BO Settings? What is your power, frequency, duty, feedrate, gas pressure? it it a 45CF-R resonator or 60XF? What pierce type are you using?

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor