Cutter

[taled]

Hi,

I'm trying to model a cutter similar to the dog biscuit shaped cutter half way down this page:

http://www.manufacturingcenter.com/man/articles/0106/0106cad_cam.asp

any suggestions on how to keep the sides of the cutting shapes always at 90degrees to the pin?

Thanks

 

[rfus]

You are going to use the wrap feature. Make a sketch of the bone and use the wrap feature to emboss it on the roll. Then use a liner and circular pattern without geometry pattern. Viola!

RFUS

 

[taled]

Thanks. I'll give that a go now!

 

[taled]

it worked! thanks!