How to use function cutter compensation and to see in display correctly tool path ?
If I change TANTO to ON then programm generates me correctly NC but my mill on display goes me on the center edge and workpeace cuts. NC code is correctly but for UG display it is wrong.
If I put TANTO this is well only for display but programm add and beyond just G41 or G42 and does not generate on contour points correctly.
Please !!!!!!
If I change TANTO to ON then programm generates me correctly NC but my mill on display goes me on the center edge and workpeace cuts. NC code is correctly but for UG display it is wrong.
If I put TANTO this is well only for display but programm add and beyond just G41 or G42 and does not generate on contour points correctly.
Please !!!!!!
