Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cut with surface problem 1

Status
Not open for further replies.

CMorehead

Mechanical
Joined
Jul 20, 2007
Messages
31
Location
US
I can't figure out why I can't use Surface Offset 8 so that I can use Cut With Surface. When I try this I get an error message. The part can be found here.



I remove the check mark from Auto Select and manually select the 14 solid bodies. The error message I get is Operation Failed Due To Geometric Condition. I don't find this message to be very helpful.
 
You need to extend the surface seen in the left view so that it extends past the solid bodies.

[cheers]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top