rlj4794
Mechanical
- Jan 18, 2006
- 38
I use a lot of PEM fasteners, and I would like to create specific PEM holes using hole wizard and have custom hole callouts in my drawings that reflect the PEM requirements and call out the fastener used.
I looked at "custom standards" in SW help, and it didn't do me much good. I noticed that I could had the option of creating a standards database derived from "PEM inch", but I couldn't locate the PEM inch database anywhere.
I also looked at this thread: thread559-62976, and it appears that I would have to edit the .mdb files, which I would prefer not to do.
Am I missing something obvious that can be done fairly easily?
I looked at "custom standards" in SW help, and it didn't do me much good. I noticed that I could had the option of creating a standards database derived from "PEM inch", but I couldn't locate the PEM inch database anywhere.
I also looked at this thread: thread559-62976, and it appears that I would have to edit the .mdb files, which I would prefer not to do.
Am I missing something obvious that can be done fairly easily?