-
1
- #1
Nougatti
Mechanical
- Jun 29, 2012
- 36
Picking up where thread561-276946 left off.
Came across this nifty tutorial for creating custom crosshatching in NX. See pages 356 to 361 in the attached pdf-file! There are some limitations to how well you can define these, so a good looking "concrete crosshatching" is probably unreachable. Regardless, it explains it well
I am Norwegian.
I design mechanicals for hydroelectric powerplants.
I use NX 6.0.5.3
----------------------------
Tom you can't knit at these speeds! Nobody can! DON'T BE A GODDAMNED HERO TOM!
Came across this nifty tutorial for creating custom crosshatching in NX. See pages 356 to 361 in the attached pdf-file! There are some limitations to how well you can define these, so a good looking "concrete crosshatching" is probably unreachable. Regardless, it explains it well
I am Norwegian.
I design mechanicals for hydroelectric powerplants.
I use NX 6.0.5.3
----------------------------
Tom you can't knit at these speeds! Nobody can! DON'T BE A GODDAMNED HERO TOM!