Custom BOM Callouts ?? 1

[Nella95]

In every individual instance of a part I created a separate configuration (a letter) -and create a separate custom property corresponding to that letter. In the assembly, I call out each individual instance. - When I go to the drawing, it works just fine, I go to the individual BOM callout - go to Custom Properties, then select the letter ID I created. This works flawlessy for one view on the drawing - however in other views (that are projected views off the working view) - it doesn't work, the Letter ID custom property that I created doesn't show up. What gives? Any thoughts?


SW Professional 2012
64 bit SP1.0
Intel Xeon X(R) CPU 1603 0 @ 2.80 GHz
8.0 GB of RAM

 

[handleman]

Can you post the files?

-handleman, CSWP (The new, easy test)

 

[Nella95]

Yes - I need an answer - but I have bigger fish to fry at the moment - will return after noon.

SW Professional 2012
64 bit SP1.0
Intel Xeon X(R) CPU 1603 0 @ 2.80 GHz
8.0 GB of RAM

 

[EEnd]

Different views can have different BoMs. BoMs have a property for grouping all configurations into a single line. Could the other views be sourcing their callouts from BoMs with configurations grouped?

Eric