I believe you are asking about routine sampling (every 5 feet or so) to get samples for description, classification tests, and approximate strength tests. From what I see, the practice has advanced very little and actually regressed since Hvorslev's day. I grew up in a company with California roots, and we used the 2" California sampler routinely. It was OK for very stiff clays, and sample handling was convenient. It tended to compress unsaturated soils including loess and fill. I was able to improve on that by designing a tip with a sharp, long-tapered bevel and an interior bevel that made the tip cut a sample a little smaller than the ID of the tubes. If the sample could be pushed out of the tube with the thumb, it probably hadn't compressed much going in. We had our samplers built to spec by a local machine shop. You can probably have tubes made the same way. The main trick is to throw the tips away when they get dulled or chipped. For cohesive soils, I believe California sampler is still much better than a split spoon. It is seldom suitable for consolidation testing.
In much of the south, the clays are stiff to hard, and the main question is how much will the soil swell. The standard sampler is a thick-walled 3" tube that looks like a Shelby tube, but the wall is thicker and the tip is not swedged to cut an undersized sample. Some drillers are still using the tubes they started with 20 years ago. When they get nicked and bent on the tip, they saw them off. The more picky ones grind the tip sharp, but some just use the blunt cut end! The recovery is poor, but improved by pushing a 16-inch long tube 24 inches.
You probably won't have to try very hard to improve on the local practice. Read Hvorslev and recognize the principles. Are you concerned about reducing the undrained strength by remolding the sample too much, or increasing the apparent strength by compressing the sample due to high perimeter friction? buck the tide and try to improve your profession.
For more important strength and consolidation testing, Shelby tubes are still the standard. Piston samplers or foil samplers may be justified for very soft or sensitive soils. Larger-diameter Shelby tubes generally get less-disturbed samples. Don't over-push the sampler, and reduce the push to 12 inches or so for touchy soils.
Don't knock the 60s. Academics, in-situ testing,and computers have improved since then, but the local practice has deteriorated since the geotechnical report became a priced commodity.
