Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

cumulative fatigue 3

Status
Not open for further replies.

mikebb

Mechanical
Joined
Feb 25, 2010
Messages
9
Location
GB
Hi,

I am in the lengthy process of carrying-out the fatigue analysis of a transportable pressure vessel. I am using PD 5500:2003 as my guide. Have no problems so far in calculating the fatigue life associatiated with individual stress ranges. However, I dont understand the need for check (C-6), ie that sum of n/N 's are <= 1. I guess I am struggling to understand the need to combine the effects of unrelated fatigue lives to provide a cumulative value. As it stands, my figures comply, but would like to understand the need for the check. Hope someone can illuminate me !
 
I am not familiar with PD5500, but the check of cumulative life is a basic requirement for any fatigue analysis.

In the older simpler fatigue desing codes, one might have over a 50 year period 100 cold startups with each consuming 1/2000 life fraction, 2500 hot restarts with each consuming 1/10,000 life fraction. The cumulative fatigue life fraction consumed from predictable transients would then be
100/2000 + 2500/10,000 = 0.29 . If the value had turned out to be greater than 1.0, then the component would not survive the nominal 50 yr life.

Newer codes use a more sophisticated means of predicting fatigue life consumption- using the "rainflow cycle counting algorithm" to combine successive strain -time histograms - this newer procedure allows one to discard or ignore many of the smaller alternating strain ranges.
 
This is called Miner's rule or Palmgren-Miner linear damage hypothesis. The idea, as Dave pointed out is that each cycle uses up a certain fraction of the materials fatigue life.

Note: even with rainflow counting Miner's rule is still used to accumulate fatigue damage due to different types of cycles.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top