Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cropping an Iso View

Status
Not open for further replies.

djw2k3

Mechanical
Joined
Jan 20, 2003
Messages
190
Hi,

Have just drawn a closed spline to crop an isometric drawing view.

Get the error "This view cannot be unfolded any further"

First time I have ever seen this error. Any ideas out there??

Thanks in Advance

Dave
 
ops, using SW2001+
 
I have tried making a crop view of an Isometric view in both SW03 and SW01+ and it worked fine in both. (SW01+ SP6)

Is this a sheet metal part that you trying to crop?

Try croping say the front view or side view and see if that works.

Try making a new drawing and placing that part in there and see if you can crop it there.

Regards,


Scott Baugh, CSWP [spin] [americanflag]
3DVision Technologies
faq731-376
When in doubt, always check the help
 
Hi Steve,

Yeah this is the first time I have ever had this problem with cropping a view - Its of an assembly ~500 Parts, am running SW01-SP6, will have another play at some stage and see if I can find the prob.

djw
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top