CROP LINES SHOWING...

[gatnact]

I am trying to get rid of the lines around the crop view. When I try to crop parts in my assembly it leaves behind the lines I used for the crop I need to get rid of all of these lines. Does anyone know how to do this?

 

[Theophilus]

I'm not sure--but if you used a sketch to define this view, perhaps you need to right-click that sketch and select Hide.



Jeff Mowry

http://www.industrialdesignhaus.com

Reason trumps all. And awe transcends reason.

 

[CorBlimeyLimey]

Do you still have the uncertified video card? If so that's probably why you are seeing the crop lines.

Unless you get an approved card and driver combination you will often get graphic anomalies.

 

[mncad]

gatnact,

Depending on your version and SP this has been discussed on here before. Check thread559-130988. The last few versions did that for me unless I put the spline in a certain way. SW07 doesn't seem to have this problem.

mncad

 

[gatnact]

I am running SW07. I dont think that the video card is the problem. It stays on there when I plot my drawings. I have also tried to put my crop boundries in several different ways.