Creo won't regenerate fully

[CPiotrowski]

I have an annoying problem that I'm hoping someone knows how to solve...

While working with models with either a skeleton, copy geom or both, I get a second regeneration after a feature is completed. However, the second regen wont happen until I click on the screen or rotate the model. When I click the screen or rotate the model...it goes back into another regen...sometimes briefly and sometimes not depending on how far down the model tree I am. This is ultimately costing me quite a bit of time. Do you know what could be causing this? Is it a config setting? I have auto-regen turned off permanently and making the skeleton read-only doesn't make a difference.

Thanks in advance.

 

[design-engine]

can you upload the model?

 

[CPiotrowski]

can you upload the model?

Hey Bart...been a while, hope you're doing well buddy.

Unfortunately I can't upload the model as it's proprietary and a huge cylinder block model.

 

[jabbadeus]

I've never seen a situation where the second regeneration happens upon manipulating the model.

Does the model have any circular references?