Creo Tutorial - Toyota 86

[bowlofnoodle]

G'day All,

I have put together a tutorial on how to create complex
surfaces of a Toyota 86 car on YouTube. Check it out,
tell me what you think.

Part 1 - Setup ref blueprint
<a href="http://youtu.be/AnjJMymZSSY" target="_blank">http://youtu.be/AnjJMymZ
SSY</a>
Part 2 - Using the Style Tool to draw 3D curves
<a href="http://youtu.be/BMH7-HVF00c" target="_blank">http://youtu.be/BMH7-
HVF00c</a>
Part 3 - Using Style Tool to create side panel and wheel
arch
<a href="http://youtu.be/G_tGmt6JJW4" target="_blank">http://youtu.be/G_tGmt6J
JW4</a>
Part 4 - Using Style Tool to create surface with many
profile
<a href="http://youtu.be/tiVHCn195_4" target="_blank">http://youtu.be/tiVHCn19
5_4</a>
Part 5 - Using Style Tool to blend 2 surface edges
<a href="http://youtu.be/7ncO_mQt6pM" target="_blank">http://youtu.be/7ncO_mQ
t6pM</a>

go4322.jpg">
Edited by: bowlofnoodle

 

[muadib3d]

I see you did not bother with something like 3 or 5 sided patches

 

[bowlofnoodle]

I am working on doing the whole car. I am trying hard to
figure out the program. After that I will update the
tutorial.