Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Creo Parametric R 2.0 - Changing scroll wheel zoom direction

Thread starter jeffatmines
Start date Oct 18, 2012

Status: Not open for further replies.

Oct 18, 2012

jeffatmines

Mechanical

I recently started a new position at a company using Creo Parametric R 2.0. This is my first exposure to Creo Parametric or anything from PTC other than MathCAD; I have formerly used Solidworks and CATIA V5. Is there a way in Creo to change the direction the scroll wheel zooms in and out? I've asked around and no one around the office seems to know. I figured the Creo Simulate forum would be a good place to start. I'm posting this in the Pro/Eingineer forum as well since there isn't a forum for Creo Parametric yet. Thanks in advance!

Jeff Parham
Colorado School of Mines '09
Mecahnical Design Engineer