Creo 2: Disabling the Pop-up box regarding the use of alt when selecting

[hrwind]

Is there a way to permanently disable the yellow pop-up box regarding the use of alt when selecting? Every time I start a new session I am interrupted by this box. It is irritating, and I want it gone... forever.

 

[pramit.associat]

Do u mean while sketching selection the alt disable or anything else?

 

[silverado8405]

Even when you click the check mark to make it go away forever, it still comes back. I asked our software rep about it and they said they haven't found a solution, just heard a ton of complaints about it.

 

[mjcole_ptc]

Try checking the never show again then Exit ProE/Creo and see if it appears next session.
Never Show again may also just be session specific. Search for an option to set in your config.pro

 

[silverado8405]

I'd wear my mouse out clicking on never show again, it just keeps coming back. Tried a few times to find a config option but I may not be searching for the right terms....