Creating assemblies from parametrically created parts

[Settler]

Hello all,

I'm sure that some of you might have faced this problem before. My question is:

Let's say I have an assembly made of two parts but I have parametrically created those parts so that I have 3 configurations (from the design tables). That gives 9 assembly combinations assuming all combinations are compatible. Is there a way to create all the possible assemblies or should I create the design tables again in the assembly configuration?

If so how should I refer the dimension I want to change (D1@Sketch1@Partname)?

Thanks a lot in advance!

 

[CorBlimeyLimey]

Design tables at the part level establish part configurations & control feature suppression states & dimension variations.
Design tables at the assy level establish assy configurations & control which part configurations are shown.

 

[Settler]

Any link that could be useful for the assembly level design tables?

Thanks

 

[CorBlimeyLimey]

http://help.solidworks.com/2014/English/solidworks/sldworks/c_configurations_overview.htm

https://www.google.ca/?gws_rd=ssl#q=solidworks+configurations+youtube

 

[TheTick]

The shortcut to design tables...

Before making the table, make configurations, then make configuration-specific changes. Then create the table in auto mode and the config-specific parameters will be included.

You don't even need to make all your configurations. Make 2 or 3, then add the rest of the configs from the table.

 

[Settler]

Thank you guys!

Your help was extremely helpful!