Jul 23, 2007 #1 victroladoctor Civil/Environmental Joined Dec 13, 2006 Messages 10 Location US I have a drawing with points and I have been asked to creat a tri-mesh for AGTEK to read. Is this possible and if so How?
I have a drawing with points and I have been asked to creat a tri-mesh for AGTEK to read. Is this possible and if so How?
Jul 23, 2007 1 #2 loosestring Civil/Environmental Joined Oct 5, 2005 Messages 64 Location US I have never used AGTEK, but I'm guessing they want you to create a surface from the points. You can do this if you have Autodesk Land Desktop, but I don't believe you could with straight AutoCAD. Upvote 0 Downvote
I have never used AGTEK, but I'm guessing they want you to create a surface from the points. You can do this if you have Autodesk Land Desktop, but I don't believe you could with straight AutoCAD.
Jul 23, 2007 #3 loosestring Civil/Environmental Joined Oct 5, 2005 Messages 64 Location US I guess I should've asked... Are you running straight AutoCAD or one of the specialized versions such as Land Desktop? Upvote 0 Downvote
I guess I should've asked... Are you running straight AutoCAD or one of the specialized versions such as Land Desktop?
Jul 23, 2007 Thread starter #4 victroladoctor Civil/Environmental Joined Dec 13, 2006 Messages 10 Location US TY both I am running reg autocad 2008. I didnt think it was possible now I have confirmation. Upvote 0 Downvote
Jul 23, 2007 #5 MEM1 Civil/Environmental Joined Jan 16, 2003 Messages 144 Location US John Check your email. I sent you a link to a program that runs inside autocad. I'm not sure how Agtek will read the file. Upvote 0 Downvote
John Check your email. I sent you a link to a program that runs inside autocad. I'm not sure how Agtek will read the file.