stephen944
Military
Hi, I need to create a counter sunk hole in part or sheet metal using ST4. Does anyone know if this is even possible, if so how?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Creating a slotted counter sunk hole
- Thread starter stephen944
- Start date
- Status
More than one way to do this.
Option one, create a slot then add a chamfer around it.
Option one, create a slot then add a chamfer around it.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
Spaceballster
Mechanical
Option 2, switch to part environment, create a swept cutout, switch back to sheetmetal environment.
- Status
Similar threads
- Locked
- Question