Mar 6, 2012 #1 stephen944 Military Mar 6, 2012 1 Hi, I need to create a counter sunk hole in part or sheet metal using ST4. Does anyone know if this is even possible, if so how?
Hi, I need to create a counter sunk hole in part or sheet metal using ST4. Does anyone know if this is even possible, if so how?
Mar 6, 2012 #2 KENAT Mechanical Jun 12, 2006 18,387 More than one way to do this. Option one, create a slot then add a chamfer around it. Posting guidelines faq731-376 http://eng-tips.com/market.cfm? (probably not aimed specifically at you) What is Engineering anyway: faq1088-1484 Upvote 0 Downvote
More than one way to do this. Option one, create a slot then add a chamfer around it. Posting guidelines faq731-376 http://eng-tips.com/market.cfm? (probably not aimed specifically at you) What is Engineering anyway: faq1088-1484
Mar 20, 2012 #3 Spaceballster Mechanical Jun 18, 2009 49 Option 2, switch to part environment, create a swept cutout, switch back to sheetmetal environment. Upvote 0 Downvote
