Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
create cross section with element beam188
- Thread starter jmf2011
- Start date
- Thread starter
- #3
Ok,
You have the option to input user defined cross sections. However, in this case, you need the input the inertia and area yourself. ANSYS will not calculate it for you. In Common Section - subtype, you will find a smily face. Just enter your beam's properties that you will get what you need.
Hope it helps.
Cheers.
You have the option to input user defined cross sections. However, in this case, you need the input the inertia and area yourself. ANSYS will not calculate it for you. In Common Section - subtype, you will find a smily face. Just enter your beam's properties that you will get what you need.
Hope it helps.
Cheers.
- Status
Similar threads
- Locked
- Question
- Locked
- Question