Little_fox
Mechanical
Does anyone know how can I create view in drafting NX that each body will be a block line and pile up?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Create block line for each body NX drating
- Thread starter Little_fox
- Start date
- Status
Not sure what you are trying to achieve. Can you provide a picture with what you have in mind?
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX12 / TC11
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX12 / TC11
- Thread starter
- #3
Little_fox
Mechanical
Ah. It's like how can I create block of some lines like Autocad, so I can choose them faster.
Looks like you want to put a number of lines in one group.
You can use "Menu - Format - Group - New Group" to create one and add objects to that group.
If you then set the Selection Filter to group, you can select the objects by group.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX12 / TC11
You can use "Menu - Format - Group - New Group" to create one and add objects to that group.
If you then set the Selection Filter to group, you can select the objects by group.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX12 / TC11
- Thread starter
- #6
- Status
