alliok
Aerospace
- Jan 10, 2003
- 7
How do you create a surface from a point cloud? The surface will be used to cut a profile in a part.
Ken
Ken
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Create a surface from point cloud
- Thread starter alliok
- Start date
- Status
go here to get the point import macro
Bring in your ASCII delimited point data. You will then have to use selection filters to select points. Then use Insert->Curve->Through Reference Points. Use lofts, sweeps, or surface fills to create your surface from these curves. Hopefully your data is not noisey.
2007 premium has Scanto3d tools. I evald and wasn't to hot on it. I'll stick with my reverse engineering tools.
This thread was one I remember
thread559-144042
RFUS
Bring in your ASCII delimited point data. You will then have to use selection filters to select points. Then use Insert->Curve->Through Reference Points. Use lofts, sweeps, or surface fills to create your surface from these curves. Hopefully your data is not noisey.
2007 premium has Scanto3d tools. I evald and wasn't to hot on it. I'll stick with my reverse engineering tools.
This thread was one I remember
thread559-144042
RFUS
- Status
Similar threads
- Locked
- Question
- Locked
- Question
