Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Create a hole by intersecting shells in SAP2000

Status
Not open for further replies.
benjaminlafarga

benjaminlafarga

Structural
Joined
Jan 31, 2014
Messages
1
Location
DE
Hello everybody.

I am designing an intersection between one roadway tunnel and one cross passage. Both are curved surfaces modeled with longitudinal direction shells. Does exist any procedure to intersect these surfaces so I can create that hole in SAP2000. I know in SCIA is possible with the option "end cut" but I found nothing similar in SAP2000.

Thanks a lot!

Benjamin
 
Status
Not open for further replies.

Similar threads

StathPol12
  • Question Question
SAP2000 measurements
Replies
2
Views
6K
Luceid
Luceid
GJoeRMK
  • Question Question
A Sap2000 API question, SapObject.SapModel.SolidObj.AddByCoord()
Replies
2
Views
2K
GJoeRMK
GJoeRMK
K
  • Question Question
C# SAP2000 API v26.2.0 - Load Patterns Not Appearing in "Load Pattern Definitions" Table Despite Being Created
Replies
0
Views
6K
keremsari
K
Brad805
  • Locked
  • Question Question
SAP2000 Quick Plots
Replies
7
Views
2K
Brad805
Brad805
Luceid
  • Locked
  • Question Question
SAP2000 Interactive Database Bug
Replies
0
Views
1K
Luceid
Luceid

Part and Inventory Search

Sponsor

Back
Top