Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Crash running RC designer

Status
Not open for further replies.

namare

Structural
Joined
May 23, 2003
Messages
12
Location
ES
I´m using Staad 2003, in the concrete design the software crashs trying to design beams.

I made a hand-check and the moments and shears are in the normal range for the beam´s section, so there should be no problem.

There is a solution for that?

Regards
 
Send the input file to the STAAD people themselves. They should respond pretty quickly. The remedy for me (STAAD crashes regularly) is frequent saves and saves-as.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top