Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

crane wheel / shaft connection. 2

Status
Not open for further replies.

conveyorbud

Mechanical
Apr 23, 2004
21
I have a stacker wheel truck to rebuild. the space is tight. I need options besides press fit. I may be able to get a key in but there is no hub to speak of and thus set screws are out of the question. the wheel is driven so i need a positive way to tranmit the prime mover to the wheel. a creative key set-up would be preferable. If someone has a creative solution to attach a steel crane wheel to a shaft i would like to hear it.
 
Replies continue below

Recommended for you

can you give some dimensions, and loads?

Cheers

Greg Locock

Please see FAQ731-376 for tips on how to make the best use of Eng-Tips.
 
How about a Dutch pin, threaded instead of peened?

I.e., drill a hole at the hub/shaft interface, parallel to the shaft axis, right where you'd put a pair of keyseats. Half the hole in the shaft, half in whatever hub there is.

Tap it all the way through, then insert a headless setscrew, as long as the axial length of the hub, secured with Loctite.

After this, the various parts won't interchange with each other, but you probably don't care.

Of course, this only works if there's no bearing outboard of the wheel.



Mike Halloran
Pembroke Pines, FL, USA
 
A note of caution based on my experiences with stackers. All of our stackers, mostly cranes, came under heading of lifting devices as define by OSHA, governed by ANSI Standards at the time. These standards prohibited any modification of essentially any part a lifting device without written approval of the manufacture.
 
How about a splined shaft? Or a trilobular shaft? Much better torque transmission than a key.

Regards,

Cory

Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
 
Unclesyd is right; in the US, an OSHA rule trumps most anything else.

I suppose the next question is: When you rebuild a crane, do you become the manufacturer?




Mike Halloran
Pembroke Pines, FL, USA
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor