Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cracking associated with AntiHydro brand waterproofing admix

Status
Not open for further replies.

collinsj

Structural
Sep 4, 2001
2
Has anyone had cracking (shrinkage) problems when placing new concrete containing Anti-Hydro brand waterproofing admixture. The manufacturer advertises that the admix should actually reduce shrinkage cracking, but we had the opposite experience. Vertical cracks formed at approximately 4 to 5 feet on center in a wall that was roughly 18 feet high, and 2 feet thick. The concrete was cured under a water spray. Control joints (with water stops) were spaced at 20 feet on center. This project was a tank for a water treatment facility. A section of the tank wall placed later without the admixture had not such cracking.
 
Replies continue below

Recommended for you

What was the slump of the mix? and when did the water spray commence... immediately after the formwork was stripped?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor