Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COSMOS crashing SW

Status
Not open for further replies.
NL8

NL8

Mechanical
Joined
Aug 13, 2007
Messages
633
Location
US
Has anybody had this issue:

Model a part in SW, Switch to COSMOS, system works fine.
Build a simple assembly in SW, switch to COSMOS, runs fine.
build a model with more than 8 parts it seems, switch to COSMOS, SW crashes.
 
Sort by date Sort by votes
turns out it is a specific part that is cause it, but i'm not sure what is special about this part to cause this problem.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jacob999
  • Locked
  • Question Question
COSMOSM
Replies
3
Views
444
3DDave
3DDave
SWISGR8
  • Locked
  • Question Question
SW Properties disappearing when saving dwg as PDF
Replies
0
Views
212
SWISGR8
SWISGR8
bigbertha912
  • Locked
  • Question Question
How good is Cosmos/Simulation at analyzing Composite Honeycomb panels
Replies
2
Views
342
bigbertha912
bigbertha912
Bobfromoh
  • Locked
  • Question Question
COSMOS Output Files
Replies
0
Views
202
Bobfromoh
Bobfromoh
Mykolas
  • Locked
  • Question Question
how correctly to describe geometry? (COSMOS/M)
Replies
0
Views
175
Mykolas
Mykolas

Part and Inventory Search

Sponsor

Back
Top