Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

cosmetic thread problem

  • Thread starter Thread starter Sargon III
  • Start date Start date
S

Sargon III

Guest
I use SW 2012. Below you see broken-out sections of thread junctions.

https://i.imgur.com/HCfQ1UA.png

https://i.imgur.com/73R32uq.png

It is obvious that the two hatches are superimposed in the interference zone. The outer and inner thread lines are covered each other too.

I want to see the hatch pattern of the outer thread only, i. e., the outer thread to be dominant. What could I do?
 
You must log in or register to reply here.

Similar threads

DD24
  • Locked
  • Question Question
Cosmetic Thread Length Configuration
Replies
4
Views
1K
SBaugh
SBaugh
V
Problem to open a .obj file with the textures visible on the model in Solidworks 2022
Replies
0
Views
20
victor andreevich
V
drcole
  • Locked
  • Question Question
holewizzard thread nearside and farside countersink
Replies
2
Views
411
SBaugh
SBaugh
AF2023
  • Locked
  • Question Question
Problem with chamfering a tapped hole in Solidworks
Replies
15
Views
1K
ASIT859
ASIT859
VmaxVboost
  • Locked
  • Question Question
3D print plastic fuel cap, thread callout?
Replies
5
Views
336
drawoh
drawoh

Part and Inventory Search

Sponsor

Back
Top