Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
copying from sketch to drafting
- Thread starter sussi
- Start date
There's a sure fire work around. I would not consider this a best practice method but here ya go.
export you geometric set that you want in Drafter as an IGS file (save as). Rename that file with an .IG2 extension this will open in Catia drafting. Copy the newly opened veiw to the desired sheet (Paste)
You may need to dissasmeble a sketch into wire geometry first.
export you geometric set that you want in Drafter as an IGS file (save as). Rename that file with an .IG2 extension this will open in Catia drafting. Copy the newly opened veiw to the desired sheet (Paste)
You may need to dissasmeble a sketch into wire geometry first.
Or you could just do it by adjusting your options, under Tools -> Options -> Mechanical Design -> Drafting -> View, and select the radio that says "Project 3D wireframe."
You can also project 3D wireframe into existing views by right clicking, select "Properties", and checking the radio button under the View tab.
---
Professional and reliable CAD design engineering services - Specializing in Catia V4, Catia V5, and CAD Translation. Catia V5 resources - CATBlog.
You can also project 3D wireframe into existing views by right clicking, select "Properties", and checking the radio button under the View tab.
---
Professional and reliable CAD design engineering services - Specializing in Catia V4, Catia V5, and CAD Translation. Catia V5 resources - CATBlog.
- Status
