Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

copying a curve

  • Thread starter Thread starter simo
  • Start date Start date
Status
Not open for further replies.
S

simo

Guest
hi all,

how can I to copy a daturm curve and make this curve tangent to an other daturm curve previously made?

thanks

Simo
 
Hi



try to pick on the curve (becomes red), then edit>copy,

the systems waits from you to define the new references for the copied curve.

Scale or rotate your curve to your desired position.

Now use constrains to make this new copied curve trangent to you first curve.

of course your copied curve is independed from the first.



hope this helps

xcad
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top