Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Converting multiple DText to one MText block

Status
Not open for further replies.

CRG

Mechanical
Joined
Sep 28, 2002
Messages
512
Location
US
I have a lot of drawings that have multiple lines of DText that are in a table format. Because the ASCII text does not carry equal spacing for letters, I cannot line up the text from one line of DText to the one below it. Is there a way I can copy multiple lines of DText at one time and paste into a single MText block? I would just cut and paste but this involves hundreds of drawings with each drawing having 20 to 40 lines of DText in a table.
 
Does "Txt2MTxt" on the command line help?
 
IFR,
Command does not work on my machine. Is this an express tool?
CRG
 
Yes, probably an express tool.
 
Thank you IFR and Exxit. That is just what I needed.

CRG
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top