Converting Facet Model in NX-8.5 2

[ashivu123]

How to convert Facet model into Solid or sheet body?

 

[kapmnit123]

Please check this old thread regarding reverse engineering
thread 561-394954

 

[ashivu123]

Please give me link to that thread

 

[kapmnit123]

Please search this thread on this forum

Reverse Engineering surfaces to solid bodies



Best Regards
Kapil

 

[ashivu123]

I am unable to find it

 

[kapmnit123]

http://www.eng-tips.com/viewthread.cfm?qid=394954

try this...

 

[Toost]

...

 

[ashivu123]

Unable to select Facet body by using rough offset command. Able to slect facet body in Rapid surfacing command however I am not aware of how to use that command

 

[JohnRBaker]

The ability to use a Faceted model when creating a Rough Offset was not supported until NX 9.0.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[ashivu123]

What Can I do in NX-8.5??