Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

contour variation during animation 1

Status
Not open for further replies.
jargon5

jargon5

Aerospace
Joined
Aug 11, 2005
Messages
27
Location
US
Does anyone know how to allow the stresses to change with the part in animation mode in FEMAP post-processing? This would help demonstrate where the peak values are (compression, tension, etc.).
 
Sort by date Sort by votes
View, Options, Postprocessing, Contour/Criteria Levels, and then check the upper right, the animate box.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

BennyS
  • Locked
  • Question Question
Stiffness variation approaches in Nastran
Replies
0
Views
243
BennyS
BennyS
MrRogers1987
  • Locked
  • Question Question
Segmentation Fault During Analysis
Replies
2
Views
252
MrRogers1987
MrRogers1987

Part and Inventory Search

Sponsor

Back
Top