Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Constrain Set

  • Thread starter Thread starter fabiogeraci
  • Start date Start date
Status
Not open for further replies.
F

fabiogeraci

Guest
Greeting,



Does anybody know when Pro/Mech Applies the Constrain Sets?



I have defined 4 constrain sets, and I am suspecting that Pro/mech is applying only the first one and ignoring the other 3....



Thanks
 
I found the answer I was looking for, but if you want to comment or have any suggestion please reply to this topic....



Fabio
 
yes, because pro/mechanical take in account just one Constrain Sets per analysis, but if you want to model differents constrains at the same time, include all just in one constrain set.


Napoleon
 
Status
Not open for further replies.

Similar threads

BryanAyers
  • Locked
  • Question Question
Creo 9 drawing's tables, "part perimeter", how to setup?
Replies
0
Views
858
BryanAyers
BryanAyers
V
How to properly set up the limits of a simulation?
Replies
0
Views
7K
Villa
V
V
CREO Simulate & Simulation Limits / Constraints
Replies
2
Views
11K
Villa
V
M
Tutorial for Setting up Oscillating Servo-Motor in Mechanism Appl
Replies
1
Views
11K
jay.coker
J
P
Connection condition setup issues (Can't succeed the joints constrain condtion)
Replies
0
Views
5K
pubojeff
P

Part and Inventory Search

Sponsor

Back
Top