I would like to constrain a round "tooling ball" to the surface of a block. Is there an easy way to do this, do both components need to be in an assembly and use assembly constraints? If so, what is the procedure to do this? Any advice would be appreciated thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Constrain an object to another
- Thread starter JChurch77
- Start date
- Thread starter
- #2
Are you using Cadkey or KeyCreator? Cadkey wasn’t able to do assemblies. Cadkey, now KeyCreator is a direct modeler, no need for constraints.
This forum is dead, have you tried posting on the Kubotek webforum? Lots of users there. You don’t need to be current on maintenance to post, just a legal user.
This forum is dead, have you tried posting on the Kubotek webforum? Lots of users there. You don’t need to be current on maintenance to post, just a legal user.
- Thread starter
- #4
Access KeyCreator University - there are many tutorials PDF and KeyCreator movies on many topics:
Most of the content can be accesses without a customer number.
If that doesn't help, there is also a linked-in and Facebook page for KeyCreator. The links are located on the header of the website page for Kubotek USA:
They also have a phone number for support there 800-372-3872.
I hope that helps.
Scott
Most of the content can be accesses without a customer number.
If that doesn't help, there is also a linked-in and Facebook page for KeyCreator. The links are located on the header of the website page for Kubotek USA:
They also have a phone number for support there 800-372-3872.
I hope that helps.
Scott
- Status
Similar threads
- Locked
- Question
- Locked
- Helpful tip