Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Consolidated "W" 1900 valves
- Thread starter LaSaga
- Start date
Which Setting Device are you using?
1566 Hydroset?
1566-2 Hydroset?
Dresser EVT Electronic?
There are several Alternatives:
AVK
Trevitest
J. Alton Cox
1566 Hydroset?
1566-2 Hydroset?
Dresser EVT Electronic?
There are several Alternatives:
AVK
Trevitest
J. Alton Cox
- Thread starter
- #3
Hello Mr. Cox
None of these devices, what I am talking about is a jig, made by barber. You cannot ajust the set pressure the conventional way. You have to apply this jig to remove the spring tention, before you can adjust the pressure. Then you have to remove this jig, befor you can atempt to test it.
None of these devices, what I am talking about is a jig, made by barber. You cannot ajust the set pressure the conventional way. You have to apply this jig to remove the spring tention, before you can adjust the pressure. Then you have to remove this jig, befor you can atempt to test it.
OK, I know the device to which you refer.
Unfortunately, due to the size of the "W" Orifice,
It is very difficult to adjust the Set Pressure.
We manufacture custom designed Relief Valve Test Equipment.
We could take a look at this to see if there is something we could offer, if you have time for us to look at the project. Is the Barber Jig Hydraulic or Mechanical?
J. Alton Cox
Unfortunately, due to the size of the "W" Orifice,
It is very difficult to adjust the Set Pressure.
We manufacture custom designed Relief Valve Test Equipment.
We could take a look at this to see if there is something we could offer, if you have time for us to look at the project. Is the Barber Jig Hydraulic or Mechanical?
J. Alton Cox
- Status
Similar threads
- Question
