Connection region 1

[Grozozo]

Hello,

Just quick question. If one alredy defined connection region which are defined by surfaces, after remeshing solid or surface where region is defined, does region update elements included in region, or is needed to again define connection region?

Grozozo.

 

[NRP99]

Which software are you using?

Most of the FEA software(s) store information of elements and nodes for the surface set. But usually the information is modified when remeshing is done. Some software(s) may not modify this information. You can check this by highlighting the elements/nodes for this surface set whether they are modified or not after remeshing.

 

[Grozozo]

Yes, i forgot to say, i am using Femap, thank you for answer. I just needed to confirm, just to be sure. Thanks again.

Grozozo.