Mar 12, 2003 #1 xcaos Mechanical Joined Nov 3, 2002 Messages 6 Location PT Can anybody tell me how to make an conical hole? Thank you.
Mar 12, 2003 #2 MadMango Mechanical Joined May 1, 2001 Messages 6,992 Location US There are several different methods... Centerline and tappered profile that you revolve-cut. Cut-extrusion with an applied draft. It realy depends on what the design intent is and what are the governing factors for the conical hole. Ray Reynolds Senior Designer Ricon Corp. http://www.riconcorp.comfaq731-376 Upvote 0 Downvote
There are several different methods... Centerline and tappered profile that you revolve-cut. Cut-extrusion with an applied draft. It realy depends on what the design intent is and what are the governing factors for the conical hole. Ray Reynolds Senior Designer Ricon Corp. http://www.riconcorp.comfaq731-376
Mar 13, 2003 #3 TheTick Mechanical Joined Mar 5, 2003 Messages 10,194 Location US If you are making a countersunk hole, try the "Hole Wizard" Gravity is a harsh mistress. Upvote 0 Downvote