Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cone Large End Not Adequately Reinforced!

Status
Not open for further replies.
behanan

behanan

Mechanical
Joined
Jun 10, 2019
Messages
13
Location
IN
The half apex angle is 54 degree > 30deg, How to reinforce the large end of cone?
Conical bottom head failed, showing the large end of the cone is overstressed.
How to find the solution to this problem
 
Sort by date Sort by votes
show us pictures and need more details during which process the failure occurred.
 
Upvote 0 Downvote
chicopee , Thanks I got the answer
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

vpkhati
  • Locked
  • Question Question
Tubesheet to 'cone' shell joint welding
Replies
4
Views
3K
r6155
r6155
mrmyagi
  • Question Question
Question regarding EN13480-5 Built up pipe end
Replies
2
Views
599
mrmyagi
mrmyagi
AM424
  • Locked
  • Question Question
Steam Accumulator Large Quantity Blowdown Advice
Replies
1
Views
2K
FacEngrPE
FacEngrPE
XL83NL
  • Locked
  • Question Question
ASME VIII-1 guidance on threaded end cap
Replies
12
Views
4K
XL83NL
XL83NL
FPPE
  • Locked
  • Question Question
API 660 loads on BEM Heat Exchanger Channel with Concentric Cone
Replies
14
Views
5K
GD2
GD2

Part and Inventory Search

Sponsor

Back
Top