Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Condensate load for steam trap

Status
Not open for further replies.
NPC5

NPC5

Chemical
Nov 24, 2008
15
Does anyone know a quick method of calculating the condensate load for a line steam trap? I am looking at a 16" line flowing 50 psig saturated steam with drip legs and steam traps located every 100 feet. Thanks!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
What's the conditions of the condensate return header? Check out Spirax Sarco website.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Pavan Kumar
  • Locked
  • Question
LP Condensate to Condensate Header Feasibility Check.
Replies
16
Views
7K
Pavan Kumar
Pavan Kumar
Pavan Kumar
  • Locked
  • Question
Steam Mains Pressure Control Valve Sizing 1
2
Replies
28
Views
9K
pierreick
pierreick
Designer80
  • Locked
  • Question
Low Pressure Steam Bellow Failure 3
2
Replies
31
Views
8K
LittleInch
LittleInch
Sawsan311
  • Locked
  • Question
Allocation of Water in waste heat steam generators 1
Replies
3
Views
669
georgeverghese
georgeverghese
vanillabeans12
  • Locked
  • Question
Solutions heating in tank with steam injection calculation
Replies
0
Views
554
vanillabeans12
vanillabeans12

Part and Inventory Search

Sponsor

Back
Top Bottom