Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Compress software output 1

Status
Not open for further replies.
JDS1

JDS1

Mechanical
Jun 28, 2007
1
Does anyone use Compress software output to build a SolidWorks model
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I don't see how this is possible currently. But perhaps some users have figured out how to do this.

Our plans for the future include implementing a 3D solid model interface for COMPRESS to replace the current graphical model. A lot of work has been done on this but it still remains a ways off.

Tom Barsh
Codeware Technical Support
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Amr Shams
  • Locked
  • Question
Assistance for Multi-Chamber Vessel Design in COMPRESS
Replies
2
Views
3K
amillsmuel
A
withak36301
  • Locked
  • Question
Seismic Calculations in Compress Without Supports 1
Replies
2
Views
872
withak36301
withak36301
Amr Shams
  • Question
Advisory Warning on CS-2 Vacuum Chart Temperature Limit- Allowable compressive stress
Replies
0
Views
2K
Amr Shams
Amr Shams
uglyspec
  • Locked
  • Question
Compress FEA Module
Replies
3
Views
959
Sue23
Sue23
txcadman
  • Locked
  • Question
Compress and UG-45 on old vessels 1
Replies
1
Views
766
Cobra17
Cobra17

Part and Inventory Search

Sponsor

Back
Top Bottom