Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Complex Surfacing Fin/Skeg shape.

Thread starter CPosner
Start date Aug 10, 2010

Status: Not open for further replies.

Aug 10, 2010

CPosner

Mechanical

I'm referencing an old thread I started about modeling a fin...
thread560-210022

Update: I'm developing some fins and some have been scanned via reverse engineering processes.

I'm having the same predicament about modeling the tip. I couldn't really figure out the last bit described in the previous thread. Any more insight is greatly appreciated.

Thanks.