Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

command line error in calculations

Status
Not open for further replies.
agodave

agodave

Industrial
Joined
Dec 8, 2006
Messages
4
If I'm working in an inch drawing and need to convert to metric to do an offset or drawing. When I do this the system rounds off and does not calulate to a high precision. Do anyone have any ideas where to change this if possible. for example 2.73/25.4 = .1074803 in draftsight I get .1092 or an erro rof .00172 inches.

Any ideas

Dave


 
Status
Not open for further replies.

Similar threads

BarryCole
  • Locked
  • Question Question
Line colours
Replies
0
Views
756
BarryCole
BarryCole
PLCAlligator
  • Locked
  • Question Question
Unable to Import a PDF into a DWG/DXF File in Draftsight 2020 Enterprise
Replies
0
Views
1K
PLCAlligator
PLCAlligator
MechEngLR
  • Locked
  • Question Question
Angle Line Command
Replies
0
Views
419
MechEngLR
MechEngLR
Lstern
  • Locked
  • Question Question
Trimming seems bugged in 2022 Draftsight
Replies
0
Views
847
Lstern
Lstern
parsakaali
  • Locked
  • Question Question
_FROM command modifier no longer working
Replies
2
Views
323
parsakaali
parsakaali

Part and Inventory Search

Sponsor

Back
Top