Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

command for spring force control in ansys workbench

Status
Not open for further replies.

pzahedinejad

Mechanical
Joined
Dec 2, 2013
Messages
1
Hi,
I am performing a transient analysis on a forced vibration spring mass system.
I want to get the amounth of spring force in each substep and check it with a predefined value and omit the spring if the force be larger than the specified value.
does any body know how can I write a command in ansys workbench to get this operation?
I will be so thankful if any body could help me.
best regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top