Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COMBINATION OF SHELLS AND BEAMS

Status
Not open for further replies.
3JC

3JC

Mechanical
Joined
Jul 12, 2010
Messages
98
Location
PE
Dear collages,

In the model that I'm performing in this moment, I combine shells and beams. But when I submit the calculations, I obtain some warnings about unconnected regions. I would like to know how to connect shells and beams, please.


Regards,

Juan José
 
Status
Not open for further replies.

Similar threads

D
  • Question Question
(ABAQUS) Earlier Failure and Unrealistic Cracking of Reinforced High Strength Concrete Beam Under Bending Simulation
Replies
4
Views
15K
Daniel_LEE
D
zenzizenzizenzic
  • Locked
  • Question Question
How to find ultimate strength and fracture sequence of bolted connections to thin-walledcarbon steel
Replies
2
Views
2K
zenzizenzizenzic
zenzizenzizenzic
g.alshamsi
  • Locked
  • Question Question
Principal Stresses in Shells (S4R) - Section Points
Replies
2
Views
475
g.alshamsi
g.alshamsi
polak7
  • Solved
ECAP - material flows between the punch and the die?
Replies
4
Views
8K
polak7
polak7
B
  • Locked
  • Question Question
Adaptive remeshing and Swept ? Structured meshes?
Replies
2
Views
2K
Vishakh_Rajendran
Vishakh_Rajendran

Part and Inventory Search

Sponsor

Back
Top