Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Column tray thickness and width

Status
Not open for further replies.
MMiyan

MMiyan

Mechanical
Joined
Dec 11, 2014
Messages
9
Location
IN
Dear Sir,

Please suggest the thickness and width of internal tray support ring for column to design
 
Sort by date Sort by votes
In inches; 2" x 2" x 3/16" angle iron, installed "Leg out & Leg Down". Further, use these tray rings as vacuum stays in the vessel calculations. You will find that a Full Vacuum rating is available.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

oldisgold981
  • Locked
  • Question Question
Annular plate thickness
Replies
5
Views
5K
oldisgold981
oldisgold981
toque73
  • Question Question
API5CT nominal linear weight and PE linear weight
Replies
0
Views
480
toque73
toque73
daily123214
  • Locked
  • Question Question
Minimum Thickness with changing radius
Replies
2
Views
496
daily123214
daily123214
Lorenzo Loreto
  • Locked
  • Question Question
API 650 Tank Rebuild - Type and quantity of weld inspections
Replies
8
Views
6K
IFRs
IFRs
Water_Guy
  • Locked
  • Question Question
API 579 - MAT and temperature reduction
Replies
2
Views
1K
Water_Guy
Water_Guy

Part and Inventory Search

Sponsor

Back
Top