Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COLCHESTER FEED SHEAR PIN

Status
Not open for further replies.
BRUMMIEBALTI

BRUMMIEBALTI

Mechanical
Joined
Jun 19, 2004
Messages
1
Location
GB
I have a colchester triumph 2000 lathe and i think the shear pin on the feed needs replacing, as i don't have the manual for this lathe can somebody tell me how to replace it.
 
Sort by date Sort by votes
I think the shear pin is located down just below the chuck where the shaft enters the housing of the machine.
If the feed shaft is still visibly turning then there is a sleeve under the saddle has worn out and needs replaced £££.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

S
  • Question Question
Need feedback on my jig design for welding aluminum sheet metal – flatness + dimensional control is key
Replies
10
Views
14K
gtaw
gtaw
Claypoolsbass
  • Locked
  • Question Question
Press fit a steel pin into aluminum
Replies
3
Views
2K
John Donlan
John Donlan
Vindicit
  • Locked
  • Question Question
Stamping Dies - Spring type guide pin?
Replies
5
Views
455
hendersdc
hendersdc
farzad89
  • Locked
  • Question Question
Record the real-time feed rate from CNC machine
Replies
8
Views
488
ornerynorsk
ornerynorsk
Gustavo Silvano
  • Locked
  • Question Question
Problem when feeding a motor with high frequency source
Replies
9
Views
410
jraef
jraef

Part and Inventory Search

Sponsor

Back
Top