I'm looking at applying a rubber laminate to an aluminium pulley that continues to slip. I'm stuck wondering about which rubbers produce the best coefficient of friction against other rubbers. Its a belt driven system i'm not exactly sure of the belts content. Also could anyone clarify the laminating process? Do the rubber to 6061 laminate series provide good strength before slipping its aluminium seat?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Coefficient of friction and aluminium laminates
- Thread starter TravisR
- Start date
Similar threads
- Locked
- Question
- Locked
- Question